Better syphilis infection detection for better patient care and disease prevention

Issue: BCMJ, vol. 54, No. 6, July August 2012, Pages 306-307 BC Centre for Disease Control

Syphilis, caused by the bacterium Treponema pallidum sub spp pallidum, is an infection recognized since antiquity. It was first reported in Italy at the end of 15th century.[1] Infections may be sexually transmitted as well as spread from an infected mother to her fetus or through blood transfusions. 

While T pallidum remains highly sensitive to penicillin, it remains a worldwide scourge. Globally, 25 million people are infected, with an estimated annual incidence of 12 million cases.[2] In British Columbia, syphilis infection rates are higher than the average Canadian rate, with an increasing number of infections in the men who have sex with men (MSM) population (Figure).[3]

T pallidum causes disease in three stages. Entering through intact or abrad­ed skin or mucous membrane and multiplying at the site of entry results in this spirochete causing painless ulcers in approximately 3 weeks (range 10 to 90 days) postexposure; this is the first stage of syphilis. Without treatment infections may resolve within 1 to 5 weeks. 

Humoral antibo­dies against cardiolipin (a nonspecific antigen that was discovered to cross-react well with T pallidum antigens) and treponemal antigen (from animal sources) usually do not appear until 1 to 4 weeks after the chancre. During the time the ulcer heals, T pallidum, when not stopped by treatment, spreads systemically; this is the second stage of syphilis. 

Multiple types of rashes and flu-like symptoms mimicking many other diseases may appear about 2 to 6 weeks later. The second stage (also known as secondary syphilis), if untreated, resolves within 2 to 6 weeks or the infection could go on to the third stage (called the latent or late stages of syphilis), as long as 30 years later. One-third of untreated patients with third-stage infections end up with chronic manifestations of disease including gummas (any tissue) and cardiovascular or neurological signs and symptoms.[4]

The laboratory diagnosis of sy­philis infection is complex. Since this organism cannot be cultured, serology is used. Some of the issues related to serological diagnoses are that antibodies take time to appear after infection and serology screening tests re­quire several secondary confirmatory tests that can produce complex results needing interpretation by experts in the field. T pallidum can be seen under the microscope from an appropriate clinical sample such as ulcer or cancre exudates; however, the sensitivity of this direct test is very low. 

T pallidum DNA may also be detected by polymerase chain reaction (PCR) from ap­propriate samples such as ulcer fluid, CSF, and biopsy tissue, but again test sensitivity is very low. Thus, despite its limitations, serology re­mains the mainstay for diagnosis. 

Traditionally, syphilis serology screening tests such as the rapid plasma regain (RPR) tests have been done and have used non-treponemal (using cardiolipin antigens). When positive, results were confirmed using specific treponemal tests such as Treponemaa pallidum Particle Agglutination (TPPA), or fluorescent antibody-absorption (FTA-Abs). Since RPR positive titres correlated with disease activity, it was useful for monitoring treatment or re­infections. 

Recently, due to the need for efficiencies in high-volume screen­ing and the need to address ergonomic stress of pipetting large numbers of samples, and with development of better tests, many laboratories in Canada have changed their diagnostic approach. Briefly, screening now uses semiautomated assays in which a blood sample is tested using an enzyme-linked immunosorbent assay (EIA). Screen positive samples are then tested with a quantitative non-treponemal test (e.g., RPR or VDRL). 

If any test results disagree, the specimen is also then tested using the TP-PA test as the confirmatory treponemal test. This new screening approach results in high-volume testing efficiencies, addresses ergo­nomic issues for technologists, and detects more cases (increased sensiti­vity) for early as well as latent syph­ilis.[5] One challenge with this new approach, however, is that there are more false positives due to increased test sensitivity. 

Ideally, a screening test should be simple, easy to use, provide rapid results to enhance faster therapeutic interventions, and have the sensitivity, specificity, positive and negative predictive values suitable for use in both low- and high-prevalence populations. It also needs to be cost-effective. Meeting all these testing criteria is not simple. 

In the first instance, clinicians must remain aware that this “old mimicker of many diseases” (Sir William Osler)[6] is still very much alive and well in BC and that improvements in testing, albeit challenging to laboratories, are being implemented. This is yet another good example where clinical and laboratory interface is critical for patient care. 
—Muhammad Morshed, PhD, SCCM
Program Head, Zoonotic Diseases and Emerging Pathogens, 
BCCDC Public Health 
Microbiology & Reference Laboratory, PHSA

Acknowledgments
The author would like to thank Mark Gilbert, Travis Hottes, and Stanley Wong.

This article is the opinion of the BC Centre for Disease Control and has not been peer reviewed by the BCMJ Editorial Board.


References

1.    Farhi D, Dupin N. Origins of syphilis and management in the immunocompetent patient: Facts and controversies. Clinics Dermatol 2010;28:533-538.
2.    Gerbase AC, Rowley JT, Heymann DH, et al. Global prevalence and incidence estimates of selected curable STDs. Sex Trans Infect 1998;74(Suppl1):S12-S16.
3.    Ogilvie GS, Taylor DL, Moniruzzaman A, et al. A population-based study of infectious syphilis rediagnosis in British Co­lumbia, 1995-2005. Clin Infect Dis 2009;48:1554-1558.
4.    Larson SA. Diagnostic Test. In: A manual of tests for syphilis. 9th ed. Larson SA, Pope V, Johnson RE, et al, (eds). American Public Health Association; 1998. p. 1-24.
5.    Misra S, Boily M-C, Ng V et al. The laboratory impact of changing syphilis screening from the rapid-plasma regain to a treponemal enzyme immuno assay: A case study from the greater Toronto area. Sex Trans Dis 2011;38:190-196.
6.    White RM. Unraveling the Tuskegee Study of Untreated Syphilis. Arch Intern Med 2000;160:585-598.

Muhammad Morshed, PhD, SCCM. Better syphilis infection detection for better patient care and disease prevention. BCMJ, Vol. 54, No. 6, July, August, 2012, Page(s) 306-307 - BC Centre for Disease Control.



Above is the information needed to cite this article in your paper or presentation. The International Committee of Medical Journal Editors (ICMJE) recommends the following citation style, which is the now nearly universally accepted citation style for scientific papers:
Halpern SD, Ubel PA, Caplan AL, Marion DW, Palmer AM, Schiding JK, et al. Solid-organ transplantation in HIV-infected patients. N Engl J Med. 2002;347:284-7.

About the ICMJE and citation styles

The ICMJE is small group of editors of general medical journals who first met informally in Vancouver, British Columbia, in 1978 to establish guidelines for the format of manuscripts submitted to their journals. The group became known as the Vancouver Group. Its requirements for manuscripts, including formats for bibliographic references developed by the U.S. National Library of Medicine (NLM), were first published in 1979. The Vancouver Group expanded and evolved into the International Committee of Medical Journal Editors (ICMJE), which meets annually. The ICMJE created the Recommendations for the Conduct, Reporting, Editing, and Publication of Scholarly Work in Medical Journals to help authors and editors create and distribute accurate, clear, easily accessible reports of biomedical studies.

An alternate version of ICMJE style is to additionally list the month an issue number, but since most journals use continuous pagination, the shorter form provides sufficient information to locate the reference. The NLM now lists all authors.

BCMJ standard citation style is a slight modification of the ICMJE/NLM style, as follows:

  • Only the first three authors are listed, followed by "et al."
  • There is no period after the journal name.
  • Page numbers are not abbreviated.


For more information on the ICMJE Recommendations for the Conduct, Reporting, Editing, and Publication of Scholarly Work in Medical Journals, visit www.icmje.org

BCMJ Guidelines for Authors

Leave a Reply